RUIAN LOYAL MACHINERY CO., LTD.
RUIAN LOYAL MACHINERY CO., LTD.

The Common Quality Problems of High Speed Cutting Machine The Common Quality Problems of High Speed Cutting Machine

The common quality problems in the cutting process of high-speed cutting machine:

1. The vertical stripes

The main expression is the appearance of the surface of the film roll forming a ring of ribs, linear stripes. The main reason for the vertical stripes is a large amount of air clamping in the process of cutting and collecting of the high-speed cutting machine and the poor tolerance of accumulated thickness. It is difficult to eliminate the more serious stripes.

2. The wrong layer

There is a partial membrane error on the end of the film coil, which is mainly caused by the change of thin film width during the winding process.

3. The wrinkles

This problem occurs only in the length of the beginning of the film winding, which is mainly caused by wrinkling and stripy, which is caused by a variety of factors.

4. The edge warping

The quality problem occurs at the edge position of the thin film winding, which is the thickening of the thin film edge and the edge part is raised.

5. The critical reinforcement

The quality problem is due to the obvious accumulation of film thickness tolerance and partial thickness accumulation on the surface of the film roll.

6. Insufficient length and excessive width

The quality problem is caused by the error of the roll counting or the insufficient length of the cut film and the incorrect positioning of the equipment.

Related News
  • The Introduction of Computer Control Crosscutting Machine

    The Introduction of Computer Control Crosscutting Machine

    September 11, 2017The cross-cutting machine is different from the transmission control mode. The computer crosscutting machine is controlled by the industrial control computer. With the setting length and the control o...view
  • The Notice and Classification of Roll Paper Cross-cutting Machine

    The Notice and Classification of Roll Paper Cross-cutting Machine

    September 11, 2017For the use of roller paper cutting machine, the corresponding codes of operation should be developed, it can be divided into work before and after work. Check whether all work positions are properly ...view
  • How to Prolong the Service Life of Adhesive Slitter Rewinder Machine?

    How to Prolong the Service Life of Adhesive Slitter Rewinder Machine?

    September 11, 2017The price of an adhesive slitter rewinder machine is not cheap, everyone wants to buy machines that are longer and more stable, however, to achieve this goal, the daily maintenance is very important. ...view
  • Features of Paper Rewinder

    Features of Paper Rewinder

    August 17, 2018Paper rewinder is a special equipment for mica tape and film. The rewinding process mainly accomplishes three tasks, the first is to remove the edge of the base paper; the second is to cut the whole b...view
  • The Process Requirements for Laminating Machine

    The Process Requirements for Laminating Machine

    September 11, 20171. The paper cutting machine will fit in rolls or sheets of raw materials for fixed length cutting processing, such as plastic packaging materials, packaging boxes, plates, film, leather, wood and cut...view
  • The Maintenance of the Cutting Machine②

    The Maintenance of the Cutting Machine②

    September 11, 20171. Be good at the maintenance work. First of all, the daily maintenance should be in place, its standard is, smooth, clean, liquidations (no dust, no debris) in place, ensure the equipment's sliding p...view
  • TEL:+86 0577-65652602 , +86 0577-58823960
  • EMAIL:ly@lyslitter.com
  • ADDRESS:No 88, Jinyuan Road, Dongshan Economic Development Zone, Ruian city Zhejiang province, China