The Introduction of Computer Control Crosscutting Machine
The cross-cutting machine is different from the transmission control mode. The computer crosscutting machine is controlled by the industrial control computer. With the setting length and the control of the cutting board of the cutter shaft, and the precision transmission of the mechanical part, the cutting paper error can be controlled in the range of plus or minus 1 mm. The computer control crosscutting machine has helical knife crosscutting machine and straight knife crosscutting machine. The cutter is more suitable for high speed cutting board, and the paper cutting is steady and the blade life is long. We should improve the technical quality and level of the operator, and be responsible for the operation of the control part. No one can operate without permission.
Automation Development of Hamburg Paper Cross Cutting Machinery
1. The development and changes of Hamburger paper cross cutting machinery1) Digitization: At present, most of the cross-cutting machines are controlled by computers. With the continuous development of...
The Notice and Classification of Roll Paper Cross-cutting Machine
For the use of roller paper cutting machine, the corresponding codes of operation should be developed, it can be divided into work before and after work. Check whether all work positions are properly ...
The Maintenance of the Cutting Machine②
1. Be good at the maintenance work. First of all, the daily maintenance should be in place, its standard is, smooth, clean, liquidations (no dust, no debris) in place, ensure the equipment's sliding p...
The Applicable Range of Trademark Diving and Cutting Machine
The trademarkdiving and cutting machine is an equipment which is used to cut the wide androll materials vertically. Therefore, this word is applied in all walks oflife. We can get to know this work fr...
The Maintenance of the Cutting Machine①
1. Check the pneumatic components every day. If there is a leak, repair it in time.2. Add NO. 30 oil to the slitting knife and pressure line wheel adjustment screw weekly, it can be seen that there is...
How to Load Material, Operate Membrane Anchor and Grafting Film of Paper Cutting Machine ?
The feeding of the paper cutting machine: according to the requirements of the cutting plan, and in accordance with the operating rules of driving, and according tothe actual situation, it hangs the c...